25
Con
tr
olling De
vic
es
RM-VLZ620_U (US) 4-170-639-
12
(1)
Example: To teach the DVD
input signal of your amplifier
to the DVD Device Select
button (when the DVD input
can be selected with one
button press)
1
Place the RM-VLZ620 head
to head with your device’s
remote control.
About 3 – 8 cm
(1 – 3 in.) away
Remote control for
your device
RM-VLZ620
Note
If you do not perform learning steps
within 10 seconds at any point during the
process, learning mode is canceled.
2
Press and hold
SET
for more
than 3 seconds.
While keeping
SET
held
down, press , then release
both buttons.
The
SET
indicator
lights up.
3
Enter
- 8 - 8
.
The
SET
indicator flashes three
times to indicate that the setting
mode has been entered.
3 flashes
4
Press and hold the Device
Select button you want to
teach for more than 3
seconds.
The selected Device Select button
lights up.
Notes
When teaching a
SYSTEM CONTROL
button, use a short press. Note that the
selected button does not light up.
If you do not perform the next step
within 30 seconds, the
SET
indicator
flashes once. Repeat from Step 4 again.
5
Select the DVD input on the
original remote control.
After data transfer is complete,
the
SET
indicator flashes three
times, and the RM-VLZ620
returns to the state in Step 4.
3 flashes
Note
If the
SET
indicator flashes only once, it
indicates that learning is incomplete.
Repeat from Step 4 again.
6
Repeat Steps 4 and 5 to
teach other functions.
7
Press
SET
to finish teaching.
The
SET
indicator turns off.
To cancel the process
Press
SET
anytime.
