– 18 –
1-2-26 Damper Capstan, Motor Capstan Ass’y
Removal
1) Remove the Damper Capstan
Œ
in the direction
of arrow.
2) Remove the 3 Screws
´
.
3) Remove the Motor Capstan Ass’y
ˇ
.
Assembly :
1) Match the 3 holes of Motor Capstan Ass’y
ˇ
to
the 3 holes of Main Base. Be careful not to drop or
knock the Motor Capstan Ass'y
ˇ
.
2) Tighten the 3 Screws
´
in the direction of arrow
as shown detail drawing.
3) Assemble the Damper Capstan
Œ
.
Note : After tightening screws, check if there is gap
between the head of screws and the top side of Main
Base. There should have no gap between the head of
screws and the top side of Main Base.
After reinstalling, adjusting the tape transport
system again.
B
C
A
´
3 SCREWS
Œ
DAMPER CAPSTAN
ˇ
MOTOR CAPSTAN ASS'Y
1-2-27 How to Eject the Cassette Tape
(If the unit does not operate on condition that is
inserted into housing ass’y)
1) Turn the Gear worm
Œ
clockwise with screw
driver. (Refer to arrow)
(Other method : Remove the Screw of Motor Load
Ass'y, Separate the Motor Load Ass'y)
Œ
GEAR WORM
Fig. 1-32 Damper Capstan,Motor Capstan Ass’y Removal
Fig. 1-33
2) When Slider S,T are approched in the position of
unloading, rotate holder Clutch counterclockwise
after inserting screw driver in the hole of frame's
bottom in order to wind the unwinded tape.
(Refer to Fig.1-34)
(If you rotate Gear Worm
Œ
continuously when
tape is in state of unwinding, you may cause a
tape contamination by grease and tape damage.
Be sure to wind the unwinded tape in the state of
set horizently.)
3) Rotate Gear Worm
Œ
clockwise using screw driver
again up to the state of eject mode and then pick
out the tape.(Refer to Fig.1-33)
FRAME
Fig. 1-34
