21
Co
nnec
ting Y
o
u
r
Eq
uipm
ent
Step 3: Adding a VCR
(Advanced Connection)
You can save recorded programs by adding a VCR.
1c
If your TV and VCR have A/V jacks
Connect the AUDIO/VIDEO OUTPUT
jacks of your Satellite Receiver to the A/V
input jacks of your VCR using the
supplied A/V cable.
Then, connect the A/V output jacks of
your VCR to the A/V input jacks of your
TV using an A/V cable. (Be sure to match
the colors on the jacks with the colored
plugs on the A/V cable.)
If your TV and VCR have S-Video jacks
Use an S-Video cable (supplied) instead of
the yellow video connection shown in
.
z
Tip
To allow your Satellite Receiver to control
the recording functions of your Sony VCR,
see “Step 4: Connecting the IR Controller
(Advanced Connection)” on page 22.
If your TV and VCR do not have A/V
jacks
Connect the VHF/UHF (SAT) OUT jack
on the Satellite Receiver to the VHF/UHF
input jack on your VCR using coaxial
cable.
Then, connect the VHF/UHF output jack
on your VCR to the VHF/UHF input jack
on your TV using coaxial cable.
Set the CH 3|4 switch of your VCR to the
channel that does not carry broadcasts in
your area.
Note
With this connection, your input source is
channel 3 or channel 4 depending on how
you set the CH 3
|
4 switch on your VCR.
1a
1a
1b
In
AC
S-VIDEO
TEL LINE
SERIAL
AUDIO R
AUDIO L
VIDEO
IR
OUTPUT
ACCESS CARD
SATELLITE IN
DIGITAL
AUDIO OUT
(OPTICAL)
CH
3 4
OPTIONAL
REQUIRED
CNTRL
OUT
2
1
2
1
VHF/UHF
VIDEO
L(MONO)
-AUDIO-
R
S VIDEO
IN
VIDEO S VIDEO
AUDIO
LINE
IN
LINE
OUT
IN
OUT
VHF/UHF (SAT) OUT
VHF/UHF IN
POWER OFF
PASS-THRU
ONLY
VHF/UHF
POWER OFF
PASS-THRU
Satellite Receiver
A/V Cable
TV
S Video Cable
Coaxial
Cable
Coaxial
Cable
VCR
A/V Cable
S Video Cable
1a
1a
1b
1b
1c
1c