11
SCD-C555ES
3-11. ADJUSTING PHASE OF SWING GEAR AND GEAR (U/D)
6
screw
(PTPWH M2.6)
5
stopper washer (FR)
4
Push fully the shaft of gear (shaft) and
align the hole shape of gear (loading B).
3
Let the swing gear through under the
chassis and engage its dowel
with the groove of rotary encoder.
2
Install the rotary encoder so that
its groove comes to the position
shown in the figure.
1
Insert the gear (shaft) up to the
position where its shaft comes
out by 5 mm.
g
g
h
h
f
f
f
7
gear (U/D)
8
screw
(PTPWH M2.6)
q;
screw
(PTPWH M2.6)
circle mark
circle mark
swing gear
gear (RV)
Fig. A
9
gear (RV)
Note: Align swing gear, a circle mark
on the gear (U/D), and the teeth
of gear (RV) to the position
showing in the Fig. A.
Summary of Contents for SCD-C555ES - Super Audio Cd
