14
GB
You can pick out the tracks that you like and
specify the playback order in a program
containing up to 32 steps (or 999 min. 59 sec. in
total program time).
1
Press PLAY MODE repeatedly (or
PROGRAM on the remote) in stop
mode until “PGM” appears in the
display.
2
Turn
l
AMS
L
(or press
./>
on the remote repeatedly) to select the
desired track number.
3
Press
l
AMS
L
(or ENTER on the
remote).
If you entered the wrong track number
Press CLEAR on the remote. Then repeat
Steps 2 and 3 to enter the correct track
number.
4
Repeat Steps 2 through 3 to enter other
tracks.
Each time you enter a track number, the
total number of program steps appears in
the display.
5
Press
H
.
Program Play starts.
To resume Continuous Play
Press PLAY MODE repeatedly (or CONTINUE
on the remote) in stop mode until “SHUF” and
“PGM” disappear.
Tip
The program remains even after Program Play ends.
Press
H
to play from the beginning of the program
again. The program remains even if you stop play.
Notes
• If you turn off the player, disconnect the power cord,
press
A
on the player, or switch the playback layer or
area, the program will be erased.
• If you switch the playback layer or area during
Program Play, a single track only will be played back
from its beginning, and then the program will be
erased.
Checking the contents of the
program
Before you start playing or while the player
is playing, press CHECK on the remote
repeatedly.
Each time you press the button, the track
numbers will appear in the display in the
programed order.
If you press CHECK on the remote while the
player is playing, the programed track numbers
will appear starting with the currently playing
program step.
Changing the contents of the
program
You can change the contents of the program in
stop mode.
Creating Your Own
Program
— Program Play
To
Do the following:
Erase a track
1
Press CHECK on the remote
repeatedly until the track
number you want to erase
appears.
2
Press CLEAR on the remote.
Erase from the
last track in the
program
Press CLEAR on the remote.
Each time you press the button, the
last track of the program is erased.
Add a track to the
end of the
program
Perform Steps 2 through 3.
Erase all tracks
Hold down CLEAR on the remote
or
x
(for about 2 seconds) until
“PGM CLEAR” appears in the
display.
