Ad
minis
tra
ting t
he Camer
a
Setting the Security — Security Menu
44
SSL Tab
Configure the SSL or TLS function (called “SSL”
hereafter). The settings allow the camera to
communicate with the client PC by using SSL.
Notes
• The model on sale in China does not support the SSL
function.
• When using the SSL function, always configure the
settings after setting the date and time of the camera.
If the date and time are not correctly set, it may cause
browser connection problems.
• Reload the window when you change the SSL setting.
Press the F5 key on the keyboard to reload.
Common setting
SSL function
Select
Enable
to use the SSL function.
When
Enable (Allow HTTP connection for some
clients)
is selected, both HTTP and SSL connections are
allowed. When
Enable
is selected, only SSL connection
is allowed.
When Internet Explorer is used
When SSL session is established,
appears in the right
of the address bar on your web browser.
When you use SSL connection for the first time
When you use SSL connection only with the SSL
function
Enable
, you cannot access the camera if the
SSL function does not work properly.
In this case, you must reset the camera to the factory
settings. (All settings will be initialized.)
To avoid this, check that SSL connection is possible by
performing the following steps.
1
Set the SSL function to
Enable (Allow HTTP
connection for some clients)
.
2
Click
OK
to close the viewer and the setting
window.
3
Display the viewer in SSL connection.
Refer to “Using the SSL function” on page 7 for
connection.
4
After confirming that SSL connection is possible,
set the SSL function to
Enable
.
Even if the setting window or the browser is closed as
SSL connection is impossible, http connection will be
possible if
Enable (Allow HTTP connection for some
clients)
is selected. First check the setting contents of
SSL tab in http connection, then check the SSL
connection again.
If
Enable (Allow HTTP connection for some clients)
is not selected, you will not be able to access the camera
if SSL connection becomes impossible. In this case, turn
on the power of the main unit while pressing the reset
switch on the camera to initialize. For details, refer to the
supplied Installation Manual.
Note
SSL connection will load the camera down; therefore,
not all images may be downloaded, and the
mark
may appear when the camera accesses the setting
Summary of Contents for SNCEM602R
Page 77: ...Sony Corporation ...
