Ad
minis
tra
ting t
he Camer
a
Setting the PTZ control — PTZ control Menu
52
Setting the PTZ control
— PTZ control Menu
When you click
in the Administrator menu,
the PTZ control menu appears.
The
PTZ
control menu consists of the following tab:
View angle
SNC-VB635 displays
Serial
tab, also.
View angle Tab
Zoom mode
You can select an e-Varifocal mode that has less image
quality degradation without using the digital zoom area
and the Solid PTZ mode that can shoot images further
zooming in. You can set
Image 1
,
Image 2
, and
Image
3
separately.
Notes
When selecting the e-Varifocal mode
• Select an image size other than the maximum size in
the Video codec tab.
Note that for the models
(SNC-VB600/VB600B/VM600/VM600B/VM601/
VM601B/VM602R/EB600/EB600B/EB602R/
EM600/EM601/EM602R) that have a maximum
image size: 1280 × 1024, select an image size other
than the following image sizes.
1280 × 1024, 1280 × 960, 1280 × 720
• Zoom limitation is changed depending on the selected
image size.
Home position setting
Set
Set the current position that the viewer displays as the
home position.
Reset
Reset the home position to the range of factory settings
that are shot in the maximum image size.
Image
Select the images that you want to set the angle of image
for in the e-Varifocal mode or the Solid PTZ mode.
1
Select the images that you want to set.
2
Select the images that you want to operate and
display.
3
Adjust the shooting range with the control bars
(page 17).
4
Press the
Set
button.
Note
The shooting range memorized in the
Home position
setting
is displayed after turning on the power.
OK/Cancel
See “Buttons common to every menu” on page 22.
Serial Tab
Display sample:
SNC-VB635
Supported models:
SNC-VB635
Set this setting to control other devices connected via
RS-485 interface, in which a control signal (TCP/IP
packets) from the network is converted into an RS-485
signal. Recommended setting depends on the connected
device.
TCP port No.
Set the port number to any number in the range 1024 to
65535, except well-known port numbers.
Baud rate
Set the baud rate corresponding to the connected
devices. The available baud rates are as follows. 38400,
19200, 9600, 4800, 2400, 1200(bps)
Parity bit
Select the parity corresponding to the connected
devices, from [none], [odd], [even].
Character length
Select the character length corresponding to the
connected devices, from [8], [7] (bits).
Stop bits
Select the stop bits corresponding to the connected
devices, from [2], [1] (bits).
OK/Cancel
See “Buttons common to every menu” on page 22.
PTZ control
Summary of Contents for SNCEM602R
Page 77: ...Sony Corporation ...
