Ad
minis
tra
ting t
he Camer
a
Setting the Sensor input/Camera tampering detection/Motion detection — Action input Menu
54
Note
You cannot set more than two functions for
Presence
sensor
,
Camera tampering detection
or
Network
disconnection
in the same event condition.
Interval
Specify the interval time used when condition is set to
and
,
then
.
In the case the condition is set as 1 and 2, the system
sounds an alarm when either 1 or 2 happens, and the
other happens within the specified interval.
In the case the condition is set as 1 then 2, the system
sounds an alarm when 1 happens, and then 2 happens
within the specified interval.
If you select “or” condition, this setting will be ignored.
The maximum duration to be set is 7200 seconds.
Sensor input Tab — Set the sensor
input 1/2
Sensor input mode
Set the direction of the detected input signal to the
sensor input terminal of the camera.
Normally open:
Triggers an alarm when the sensor
input is short-circuited.
Normally closed:
Triggers an alarm when the sensor
input is open-circuited.
Notes
• Allow at least two seconds for the input signal to be
detected; otherwise, some events may not be detected.
• When you use video streaming by SSL connection, set
as follows. Some events may not be detected if the
camera is not in the following conditions.
– Set the Bit rate below 1 Mbps.
– Set the Frame rate below 30 fps.
– Use the video streaming below two transmissions at
the same time.
OK/Cancel
See “Buttons common to every menu” on page 22.
Camera tampering detection Tab —
Set the camera tampering detection
Notes
• Before using the camera tampering detection function,
first adjust the focus* or the focus/zoom**.
If you adjust focus/zoom with the camera tampering
detection function activated, detection may not be
effective.
* Focus: SNC-VB635/VB630/VB600/VB600B/EB630/
EB600
** Focus/zoom: SNC-VB632D/VM630/VM600/
VM600B/VM631/VM601/VM601B/VM632R/
VM602R/EM630/EM600/EM631/EM601/EM632R/
EM602R/EB632R/EB602R
• Deselect the checkbox of
Stabilizer
in the Installation
tab of the System menu. After setting the camera
tampering detection, set the
Stabilizer
function again.
Enable
Select the checkbox to activate the function to detect
camera tampering, such as direction shifting or spray.
Detection status
Display the tampering detection state of the time when
Camera tampering detection tab is opened. To clear the
detection status, click
Clear
button.
OK/Cancel
See “Buttons common to every menu” on page 22.
Motion detection Tab — Set the
motion/VMF detection
Motion detection responds to moving objects in the
camera image and triggers an alarm.
In VMF, an alarm sounds when motion is detected under
the motion detection setting, entering or passing through
a specified area or inspection line. An alarm also sounds
when an object has been left or removed from a specified
area or inspection line.
The detected object will be displayed on the monitor in
the green frame. The removed object and left object will
be displayed in the magenta frame.
When you click the Motion detection tab, a dialog
appears. Enter the user name and password.
The factory setting of the user name and password for
the Administrator is set to “admin”.
Summary of Contents for SNCEM602R
Page 77: ...Sony Corporation ...
