21
Using the rotary
commander
The rotary commander works by pressing
buttons and/or rotating controls.
You can also control the optional CD or MD
units with the rotary commander.
By pressing buttons
(the SOURCE and MODE buttons)
Each time you press
(SOURCE)
, the
source changes as follows:
TUNER
t
CD
*
t
MD
*
t
TAPE
Pressing
(MODE)
changes the operation
in the following ways;
• Tuner:
FM1
t
FM2
t
FM3
t
MW
t
LW
• CD unit
*
:
CD1
t
CD2
t
…
• MD unit
*
: MD1
t
MD2
t
…
• Tape:
playback direction
*
If the corresponding optional equipment is
not connected, the item will not appear.
(SOURCE)
(MODE)
By rotating the control
(the SEEK/AMS control)
Rotate the control and release it to:
•Locate the beginnings of tracks on the
tape. Rotate and hold the control, and
release it to fast-wind the tape. To start
playback while fast-winding the tape,
press
(MODE)
.
•Locate a specific track on a disc. Rotate
and hold the control until you locate the
specific point in a track, then release it to
start playback.
•Tune in stations automatically. Rotate and
hold the control to find a specific station.
By pushing in and rotating the
control (the PRESET/DISC control)
Push in and rotate the control to:
•Receive the stations memorised on the
number buttons.
•Change the disc.
