Wireless Speaker
SRS-XB402M
How to care for the speaker
Although the fabric part of the unit has water repellent treatment applied, you can use the unit more comfortably and for
a longer period of time by following the maintenance procedure below.
If the surface of the unit gets dirty in the following cases, wash the unit with fresh water (tap water, etc.) promptly to
remove the dirt. Leaving dirt on its surface may cause the fabric part to discolor or deteriorate, or the unit to
malfunction.
Ex.
When salt, sand, etc. is stuck on the unit after using it on a beach, pool side, etc.
When the unit is stained with foreign substances (sunscreen, suntan oil, etc.)
If the unit gets wet, wipe off the moisture using a dry soft cloth immediately. In addition, dry the unit in an airy place
until no moisture remains.
The sound quality may change when water enters the speaker section of the unit. It is not malfunction. Wipe off the
moisture on its surface, and put the unit on a dry soft cloth with the fabric part facing down to drain the collected
water inside the unit. Then, dry the unit in an airy place until no moisture remains.
Note
If the surface of the unit gets dirty, do not use detergent, thinner, benzine, alcohol, etc. to clean the unit because it will affect the
water repellent function of the fabric part of the unit.
Especially in cold regions, be sure to wipe off the moisture after using the unit. Leaving moisture on its surface may cause the
unit to freeze and malfunction.
If sand grains, etc. enter the fabric part of the unit, remove them carefully. Never use a vacuum cleaner, etc. on the unit. It may
cause damage of the speaker unit.
5-002-064-11(1) Copyright 2019 Sony Corporation
46
