1-7
SRW-5000/5500
A'
A
Intermediate rails
Front side
Rear side
Rail bracket fixing screws
Rail bracket fixing screws
A = A' = 416 mm
Hexagon socket
head cap screw
2 pcs
Hexagon socket
head cap screw
2 pcs
Hexagon socket
head cap screw
2 pcs
Hexagon socket
head cap screw
2 pcs
2U
Plate nut (small)
Rail
Flat washer
Hexagon socket
head cap screw
L-shaped hexagon wrench
By 5U
.
Attaching the outer rails
13. Loosely attach the two outer rails to the middle of the
5U space in the rack for mounting this unit, with the
eight hexagon socket head cap screws, eight flat
washers, and four plate nuts (small).
Rail bracket fixing screws
B4
x
8
Rack
50 to 55 mm
Outer rail
Rack angle
Rail bracket
14. Check that the two intermediate rails attached to the
rack are parallel.
15. As shown in the following figure, adjust each front-
side position of the outer rails on both sides (left and
right) so that the distance from the surface of the rack
to the tip of the rail becomes within the range of 50 to
55 millimeters.
16. To fix the four rail brackets, fully tighten the eight
loosely fitted rail bracket fixing screws (B4
x
8) in
steps 11 and 12.
Tightening torque: 120
x
10
_
2
N
.
m {12.2 kgf
.
cm}
17. To fix the two outer rails to the rack, fully tighten the
eight loosely fitted hexagon socket head cap screws in
step 13 using the L-shaped hexagon wrench.
