1-42
SRW-5000/5500
Label
Eject knob
M gear
EJECT
label
Gear box assembly
AE-31 board
Board holder
EJECT
label
Wire holder
ME wire
9.
To complete the tape taking up into the cassette, repeat
steps 7 and 8.
n
On completely taking up the tape into the cassette, the
M gear will be tighten.
(Unthreading end state)
10. Check that the ME wire is slacken.
11. Open the lower control panel.
12. Turn the eject knob in the arrow direction on the label
until the cassette is completely ejected.
4.
Release the lock of the board holder and open the AE-
31 board in the arrow direction.
5.
Check by eye that the unit is in the state to be able to
take up manually the tape.
6.
Pull the ME wire for a few times with short steps to
take up the tape inside the cassette.
m
.
Be careful for the tape not to catch in parts such as a
flange of a tape guide.
.
Don’t take the ME wire off the wire holder.
.
The ME wire links with the T real table.
The T real table rotates about 1/24 turns clockwise
(take-up direction) by pulling the ME wire about 6 mm.
7.
Rotate the M gear of the gear box assembly in the
arrow direction on the EJECT label by about a half
turn to slack off the tape.
8.
Pull the ME wire for a few times with short steps in
the arrow direction on the EJECT label to take up the
tape inside the cassette.
