5-83
SRW-5000/5500
Set screw
Motor joint
Cassette compartment motor
Cassette compartment motor
A
Motor joint
Press
Spec.: 3.8 mm
A
4.2 mm
Cassette compartment motor
+
marking
Gray
Red
Installation
6. Soldering the Harness
Solder the harness’s wires disconnected in (2) of
step 5 to a new motor.
n
Solder a red wire to the side of marking “
+
” of
the motor.
7. Attaching the Motor Joint
(1) Pass the motor joint through the shaft of the
motor and temporarily tighten the set screw.
(2) Confirm that the clearance between the motor
joint and motor satisfies the specification
when the motor joint is pushed toward the
motor, and tighten the set screw.
Tightening torque: 60
x
10
_
2
N
.
m
{6 kgf
.
cm}
Harness Soldering
Attach the Motor Joint
