8-8
SRW-5000/5500
8-3-7. HDCAM SR SAT Signal Level
Adjustment
m
.
This adjustment is required in the 29.97 Hz, 25 Hz and
23.976 Hz modes.
.
Because adjustment data is automatically saved in the
NV-RAM on the EQ-94 board when the automatic
adjustment is completed, saving the data is not required.
.
Cue up the alignment tape to the time code 00:10:00:00
in advance.
When using the alignment tape not located to the time
code 00:10:00:00, exit the maintenance mode and cue it
up. Then eject the alignment tape once.
Alignment tape:
HR5-1B
1.
Set the system to the 29.97 Hz mode referring to
Section 8-1-3.
2.
Display the DT/SAT ADJUST menu.
(HOME menu
→
[SFT]
+
[DIAG]
→
[SFT]
+
[F8]
→
[ALT]
→
[F5]
→
DT/SAT ADJUST menu)
(For the DT/SAT ADJUST menu, refer to Section 3-4-
3.)
3.
Press the
[F4]
(HDSR SAT) key to display the HDSR
SAT menu.
4.
Press the
[SET]
key.
5.
Insert the alignment tape located to the time code
00:10:00:00.
.
Adjustment is executed automatically when the
alignment tape is inserted.
.
The message “Auto Adjust Complete” will be
displayed and the alignment tape will be ejected
automatically when this automatic adjustment is
completed normally.
6.
Change the system to the 25 Hz and 23.976 Hz mode
referring to Section 8-1-3, then perform the steps 2 to
7 again for each mode.
7.
Reset the system to the customer setting referring to
Section 8-1-3.
8.
Exit the maintenance mode.
8-3-6. HDCAM DT System Adjustment
Alignment tape:
HR5-1A
m
.
Cue up the alignment tape to the time code 00:10:00:00
in advance.
When using the alignment tape not located to the time
code 00:10:00:00, exit the maintenance mode and cue it
up. Then eject the alignment tape once.
.
When performing this adjustment continuously from
Section 8-3-5, start this adjustment from step 3.
1.
Activate the ALT MAINTENANCE menu.
(HOME menu
→
[SFT]
+
[DIAG]
→
[SFT]
+
[F8]
→
[ALT]
→
ALT MAINTENANCE menu)
2.
Press the
[F5]
(DT/SAT ADJ) key.
(For the DT/SAT ADJUST menu, refer to Section 3-4-
3.)
3.
Press the
[F3]
(HDCAM DT) key to display the
HDCAM DT ADJUST menu.
4.
Press the
[SET]
key.
5.
Insert the alignment tape located to the time code
00:10:00:00.
.
Adjustment is executed automatically when the
alignment tape is inserted.
.
The message “Auto Adjust Complete” will be
displayed and the alignment tape will be ejected
automatically when this automatic adjustment is
completed normally.
Saving the Data
6.
Press the
[F1]
(NVRAM CTL) key to display the NV-
RAM CONTROL menu.
7.
Select the “SAVE ALL DATA” by pressing the cursor
keys, then press the
[F10]
(EXIT) key to saving data.
.
The message “Save Complete” will be displayed
when this data save is completed normally.
8.
Press the
[F10]
(EXIT) key to exit the DT/SAT
ADJUST menu.
9.
Exit the maintenance mode.
