Home Audio System
MHC-V90DW
Connecting to a Wi-Fi network using an iPhone/iPod touch
Note that the home audio system should be reset to the factory default for this connection. All BLUETOOTH device
registration (pairing) information is deleted. To use the BLUETOOTH connection after that, delete all pairing information
on the iPhone/iPod touch, and then set pairing again.
If the iPhone/iPod touch is iOS 8 or later, the home audio system can be connected to the same Wi-Fi network as the
iPhone/iPod touch. The Wi-Fi network settings of the home audio system are made by the iPhone/iPod touch.
Do the following before starting.
Disconnect the LAN cable (not supplied) from the home audio system.
Place the home audio system near the wireless router and the iPhone/iPod touch.
Make sure that the iPhone/iPod touch is updated to iOS 8 or later.
Connect an iPhone/iPod touch to the wireless router.
Connect it to 2.4 GHz band (11b, 11g, and 11n) or 5 GHz band (11a and 11n). The home audio system does not
support IEEE 802.11ac.
1
Reset the home audio system by using the remote control.
2
Unplug the AC power cord (mains lead), then plug it back in.
1.
Press (power) button to turn on the home audio system.
2.
Press OPTIONS button.
3.
Press
/
button repeatedly to select [SYSTEM], then press
(enter) button.
4.
Press
/
button repeatedly to select [RESET], then press
(enter) button.
5.
Press
/
button repeatedly to select [YES], then press
(enter) button.
[RESET] appears on the display.
The settings of the home audio system return to their factory defaults, and network settings and all
BLUETOOTH device registration (pairing) information are deleted.
6.
Turn on the home audio system.
The power indicator lights up in green.
3
Search for the home audio system on the iPhone/iPod touch.
4
40
Summary of Contents for SS-V90DW
Page 10: ...10 ...
Page 18: ...4 694 845 31 2 Copyright 2017 Sony Corporation 18 ...