61
GB
T
unin
g
Enter the frequency of a station directly by
using the numeric buttons.
1
Press AMP.
The receiver can be operated using the
remote.
2
Press MENU.
The menu is displayed on the TV screen.
3
Press
V
/
v
repeatedly to select
“
FM” or “
AM,” then press
or
b
.
4
Press
V
/
v
to select “Direct
Tuning,” then press
.
5
Press SHIFT, then press the
numeric buttons to enter the
frequency, then press
.
Example 1: FM 102.50 MHz
Select 1
b
0
b
2
b
5
Example 2: AM 1,350 kHz
Select 1
b
3
b
5
b
0
Tip
If you have tuned in an AM station, adjust the
direction of the AM loop antenna (aerial) for
optimum reception.
If you cannot tune in a station
“– – – .– – MHz” appears and then the display
returns to the current frequency.
Make sure you have entered the right
frequency. If not, repeat step 5. If you still
cannot tune in a station, the frequency is not
used in your area.
You can change the AM tuning scale to either
9 kHz or 10 kHz on the receiver.
1
Press POWER to turn off the
receiver.
2
While holding down TUNING
MODE, press POWER on the
receiver.
3
Change the current AM tuning
scale to 9 kHz (or 10 kHz).
To reset the scale to 10 kHz (or 9 kHz),
repeat the procedure above.
Note
All preset stations will be erased when you change
the tuning scale.
Tuning into a station directly
(Direct Tuning)
Changing the AM tuning scale
POWER
TUNING MODE
Summary of Contents for STR-DA4400ES
Page 296: ...152FR X XM 67 Z Zone 12V Trigger 116 127 ZONE 2 110 ...
Page 297: ...153FR Informations complémentaires ...
Page 298: ...154FR ...
