115
US
A
d
just
ing Se
tting
s
x
AMP
The HDMI audio signals from the playback
equipment is only output to speakers
connected to the receiver. The multi-channel
sound can be played back as it is.
Note
When “Control for HDMI” is set to “On,” “Audio
Out” may be changed automatically.
Lets you turn the H.A.T.S. (High quality
digital Audio Transmission System) function
on or off. When the H.A.T.S. function is turned
on, the sound quality is enhanced because
there is no jitter (timing gaps when reading
signals) when transmitting digital audio
signals.
x
Off
x
On
Notes
• It takes some time to output the sound after a
playback operation is performed on the connected
equipment (e.g., pressing the PLAY button,
pressing the STOP button, pressing the PAUSE
button) due to limitations of the H.A.T.S. system.
The time lag depends on the sound source.
• The H.A.T.S. function of this receiver works when
a Sony SCD-XA5400ES is connected to the
receiver.
• While the H.A.T.S. function is working, sound is
not output from the front high speakers.
• The H.A.T.S. function works only when “A.F.D.
Auto,” “2ch Stereo,” or “Headphone (2ch)” is
selected.
Stream information about the
H.A.T.S. function available
Lets you turn the function which controls
equipment connected to the HDMI jack using
an HDMI cable on or off.
x
Off
x
On
Note
This function is enabled only when “Zone2 Out” is
set to “Off.”
Lets you output HDMI signals to the TV even
when the receiver is in standby mode. For
details, see “Outputting the HDMI signals
even when the receiver is in standby mode
(Pass Through)” (page 87).
x
Off
x
On
x
Auto
Lets you enable or disable the HDMI ZONE 2
OUT jacks.
x
Off
x
On
Lets you set the priority when you select the
same input for both the main zone and zone 2.
x
Main & Zone 2
You can enjoy the same input in the main zone
and zone 2. However, there may be some
interference in the audio and video signals in
the main zone and zone 2.
H.A.T.S.
Audio signal input Sampling frequency
Linear PCM 2ch
44.1 kHz, 48 kHz,
88.2 kHz, 96 kHz,
176.4 kHz, 192 kHz
Linear PCM Multi
44.1 kHz, 48 kHz,
88.2 kHz, 96 kHz,
176.4 kHz, 192 kHz
DSD
2.8224 MHz
Control for HDMI
Pass Through
Zone2 Out
Priority
continued
