134
GB
• Input signals that are more than 480i of the
COMPONENT VIDEO are not received
when signals are output from the HDMI
jack, S-VIDEO jack or VIDEO jack. (In
other words, the receiver cannot convert
the component video signals.) Input the
480i of the component video signal.
• Use a video jack as the component jack,
and set PROGRESSIVE OUT to “OFF”
when you output more than 480i input
component signals.
The source image input from the HDMI
jack is not output from an amplifier or
the TV speaker connected to the
receiver.
• Check the cable connection.
• Depending on the playback component,
component side may need to be set up.
Refer to the operating instructions
supplied with the each component.
The MULTI CHANNNEL DECODING
lamp does not light up in blue.
• Check that the playback component is
connected on a digital jack and the input is
selected properly on this receiver.
• Check whether the digital audio output of
selected input is not assigned to another
component input using DIGITAL
ASSIGN function (page 61).
• Check whether the input source of the
software being played back corresponds to
the multi channel format.
• Check whether the setup on the playback
component is set to multi channel sound.
Remote control
The remote does not function.
• Point the remote at the remote sensor on
the receiver.
• Remove any obstacles in the path between
the remote and the receiver.
• Replace all the batteries in the remote with
new ones, if they are weak.
• Check if the command modes of the
receiver and the remote are the same. If the
command mode of the receiver and the
remote are different, you cannot operate
the receiver with the remote (page 46).
• Make sure you select the correct input on
the remote.
• When “2ND ZONE” or “3RD ZONE”
appears, or when the sound fields are not
fully displayed, check if the remote is
registered for the receiver correctly (RM-
AAE003 only).
• When you operate a programmed non-
Sony component, the remote may not
function properly depending on the model
and the maker of the component (RM-
AAE003 only).
* Models of area code CEL only.
Error messages
If there is a malfunction, the display shows a
code of two numbers and a message. You can
check the condition of the system by the
message. Refer to the following table to solve
the problem. If any problem persists, consult
your nearest Sony dealer.
DECODE ERROR/CHECK CODE 01
Appears when a signal the receiver cannot
decode (ex. DTS-CD) is input when “DEC.
PRIORITY” on the CUSTOMIZE menu is
set to “PCM.” Set it to “AUTO” (page 67).
PROTECTOR/CHECK CODE 11
Irregular current is output from the
speakers. Turn off the receiver, check the
central core of a speaker cord is not touching
the receiver or other speakers, and turn on
again.
PROTECTOR/CHECK CODE 12
The amplifier section is overheated. Check
that the ventilation hole is not covered. Turn
off the receiver, leave the receiver for a
while, and turn on the power again.
