120
GB
2
Move the easy scroll key to
select “CONTRAST,” then press
the key to enter the selection.
3
Move the easy scroll key to
select “+” or “–,” then press the
key to enter the selection.
Each time you press the key, the contrast
of the display changes. To exit adjusting,
move the easy scroll key to select “Exit,”
then press the key to enter the selection.
Changing button
assignments (RM-
US106A only)
You can change the factory settings of the
input buttons to suit the components in your
system. For example, if you connect an LD
player to the VIDEO 2 jacks on the receiver,
you can set the VIDEO 2 button on this remote
to control the LD player.
Note, however, that the settings of the TUNER
button cannot be changed.
1
Press RM SET UP for more than
2 seconds.
The indicator lights up.
2
Press the input button of which
you want to change the
assignment.
The indicator turns off once and turns on
again when a valid button is pressed. Only
the first input button that is pressed will
be registered.
Example: Press VIDEO 2.
1
2,3
4
