121
GB
Us
ing
the
Re
m
o
te
3
Referring to the table below,
press the input button for the
category you want.
The indicator turns off when a valid
button is pressed.
Example: Press DVD twice.
4
Press SOURCE.
The new assignment is registered.
The indicator slowly lights up twice, then
goes off.
To cancel
Press RM SET UP during any step.
Tip
If the operation is unsuccessful, the indicator flashes
four times and the remote automatically exits the
button assignment mode. In this case, the new
assignment is not registered and the previous setting
remains.
Notes
• If you do not press a button during step 2 through 4
within 60 seconds, the remote automatically exits
the button assignment mode. Start again from step
1.
• In step 3, if you press the same button more than
the possible number of categories that can be
selected, only the last category is registered for the
new assignment.
Valid buttons and the
corresponding categories
To clear all remote button
assignments
Hold down RM SET UP, then press
?
/
1
.
The remote is reset to its factory-settings.
Corresponding
categories
Press
VTR-1
VIDEO 1 once
VTR-2
VIDEO 2 once
VTR-3
VIDEO 3 once
VTR-4
VIDEO 1 twice
VTR-5
VIDEO 2 twice
VTR-6
VIDEO 3 twice
DVD player
DVD once
LD player
DVD twice
TV
TV/SAT once
SAT
TV/SAT twice
Tape deck-A
TAPE once
Tape deck-B
TAPE twice
MD deck
MD/DAT once
DAT deck
MD/DAT twice
CD player-1
SA-CD/CD once
CD player-2
SA-CD/CD twice
CD player-3
SA-CD/CD three times
VIDEO CD player
VIDEO 1, then SA-CD/
CD
Corresponding
categories
Press
