masterpage:Left
lename[E:\SEM_Janet\Revision
Data\J9051275_2598516131DB798CEL\2598516131\GB03CON_STR-DB798-CEL.fm]
20
GB
model name1[STR-DB798]
[2-598-516-
13
(1)]
For advanced speaker setups
Set “MENU XXX” in the CUSTOMIZE menu
to “MENU EXP.” (page 40). This enables
advanced setups including those of the heights
of the surround speakers, positioning of the
surround speakers and speaker crossover
frequency.
For details on how to set the items, see page 41.
Adjust the speaker levels and balance while
listening the test tone from your listening
position.
Use the remote for the operation.
Tip
The receiver employs a test tone with a frequency
centered at 800 Hz.
1
Press
?/1
to turn on the receiver.
2
Press TEST TONE.
“AUTO L” appears in the display. The test
tone is output from each speaker in
sequence and the display will automatically
change as follows:
AUTO L (Front left)
t
AUTO C (Center)
t
AUTO R (Front right)
t
AUTO SR
(Surround right)
t
AUTO SBR (Surround
back right)*
t
AUTO SBL (Surround
back left)*
t
AUTO SL (Surround left)
t
AUTO SW (Sub woofer)
* You will only hear the test tone from the
– surround back left and right speakers when
surround back speaker selection parameter is
set to “DUAL”.
– surround back left speaker when surround
back speaker selection parameter is set to
“SINGLE”. “AUTO SB” appears in the
display instead of “AUTO SBR” or “AUTO
SBL”.
3
Adjust the speaker level and balance
using the LEVEL menu so that the level
of the test tone sounds the same from
each speaker.
For details on the LEVEL menu settings,
see page 38.
Tips
• The adjusted value are shown in the display
during adjustment.
• To adjust the level of all speakers at the same
time, press MASTER VOL +/– on the remote or
turn MASTER VOLUME –/+ on the receiver.
6: Adjusting the speaker
levels and balance
— TEST TONE
GB01COV_STR-DB798-CEL.book Page 20 Thursday, August 18, 2005 8:59 AM
