12
EN
Getting Started
Rear and center speakers
Active woofer
If your TV monitor uses separate speakers
You can connect one of them to the SURROUND OUT
CENTER terminal for use with Dolby Pro Logic
Surround Sound (see page 32).
Selecting the impedance
Set the IMPEDANCE SELECTOR for the front speakers
as indicated in the table below. Check the instruction
manual of your speakers if you’re not sure of the
impedance. (This information is usually printed on a
label on the back of the speaker.)
TV/VCR Hookups
Overview
This section describes how to connect video
components to the receiver. For specific locations of the
jacks, see the illustration below.
What cables will I need?
• Audio/video cable (not supplied) (1 for each TV or LD
player; 2 for each VCR)
• Video cable (not supplied) (1 for a TV monitor)
Hookups
The arrow
ç
indicates signal flow.
Monitor
If you are using your TV as a monitor, do not connect
anything to the TV/DBS IN jacks, unless you have a Sony TV
with TV OUT jacks (see page 25 for details).
TV tuner or DBS (Digital Broadcasting Satellites) receiver
}
]
}
]
Rear
speaker
(R)
Rear
speaker
(L)
Active woofer
REAR SPEAKERS
L
CENTER SPEAKER
R
Center
speaker
Receiver
INPUT
MIX
AUDIO
OUT
Receiver
if nominal impedance of
your speaker is
Between 4 and 8 ohms
8 ohms or higher
Set IMPEDANCE SELECTOR to
4
Ω
8
Ω
VIDEO 1
VIDEO 2
LD
MONITOR TV/DBS
L
R
L
R
TV/DBS
OUTPUT
VIDEO
IN
AUDIO
IN
VIDEO
AUDIO
Receiver
TV/DBS
Receiver
MONITOR
OUT 1
INPUT
VIDEO
OUT
TV
Yellow
Yellow
White (L)
Yellow
Red (R)
White (L)
Yellow
Red (R)
}
]
}
]
