97
US
F:\Sony SEM
HA\Revision2_DG800\JC060412_2667346121DG800_US\2667346121\US05AMP_STR-DG800-
CEL.fm
masterpage: Right
STR-DG800
2-667-346-
12
(1)
Ad
diti
on
al
I
n
fo
rmatio
n
If you are unable to remedy the
problem using the
troubleshooting guide
Clearing the receiver’s memory may remedy
the problem (page 25). However, note that all
memorized settings will be reset to their
factory settings and you will have to readjust
all settings on the receiver.
If the problem persist
Consult your nearest Sony dealer. Note that if
service personnel changes some parts during
repair, these parts may be retained.
Reference sections for clearing
the receiver’s memory
Specifications
AUDIO POWER
SPECIFICATIONS
POWER OUTPUT AND TOTAL
HARMONIC DISTORTION:
(Models of area code U only)
With 8 ohm loads, both channels driven, from
20 – 20,000 Hz; rated 100 watts per channel
minimum RMS power, with no more than
0.09% total harmonic distortion from 250
milliwatts to rated output.
Amplifier section
Models of area code U, CA
Stereo Power Output
1)
, Reference Power
Output
1)2)
8 ohms 20 Hz – 20 kHz, THD 0.09%
100 W + 100 W, 110 W/ch
8 ohms 1 kHz, THD 0.7%
110 W + 110 W, 120 W/ch
8 ohms 1 kHz, THD 10%
125 W + 125 W, 150 W/ch
1)
Measured under the following conditions:
2)
Reference power output for front, center, surround
and surround back. Depending on the sound field
settings and the source, there may be no sound
output.
To clear
See
All memorized settings
Customized sound fields
Area code
Power requirements
U, CA
120 V AC, 60 Hz
continued
US01COV_STR-DG800-CEL.book Page 97 Tuesday, March 14, 2006 3:53 PM
