[143] Adjusting Settings
Performing Auto Calibration
Selecting the Auto Calibration type (Calibration Type)
You can select a calibration type after you have performed the Auto Calibration and saved the
settings.
Note
This function does not work in the following cases:
Headphones are connected.
[Auto Calibration] has not been performed.
[Bluetooth Mode] is set to [Transmitter].
The receiver may play signals at a lower sampling frequency than the actual sampling frequency of
the input signals, depending on the audio format.
[144] Adjusting Settings
Speaker Settings
Selecting the speaker pattern (Speaker Pattern)
You can select the speaker pattern you want according to your speaker installation.
Note
This function does not work in the following cases:
Headphones are connected.
[Bluetooth Mode] is set to [Transmitter].
If you select a speaker pattern with the speakers connected to the SPEAKERS SURROUND
BACK/BI-AMP/FRONT HIGH/FRONT B terminals and select [Save], [Zone2 Power] will be set to
[Off] automatically.
Select [Setup] - [Speaker Settings] from the home menu.
1
Select [Calibration Type].
2
Select the setting you want.
Full Flat:
Makes the measurement of frequency from each speaker flat.
Engineer:
Sets to “the Sony listening room standard” frequency characteristics.
Front Reference:
Adjusts the characteristics of all of the speakers to match the
characteristics of the front speaker.
Off
3
Select [Setup] - [Speaker Settings] from the home menu.
1
Select [Speaker Pattern].
2
Select the desired speaker pattern according to the speaker installation example
displayed on the TV screen, then select [Save].
3
