Hint
You can check the remaining time before the receiver turns off on the System Settings screen. Also,
the remaining time appears on the bottom right of the TV screen when it becomes 1 minute or less.
The sleep timer will be canceled if you perform the following:
Update the software of the receiver.
Turn the receiver on or off.
[134] Using Other Features
Checking information on the receiver
Viewing information on the display panel
The display panel provides various information on the status of the receiver, such as the sound
field.
Note
Characters or marks in some languages may not be displayed.
[135] Adjusting Settings
Easy Setup
Setting up the receiver using Easy Setup
When you turn on the receiver for the first time or after the receiver is initialized, the Easy Setup
screen appears on the TV screen. You can set up the following settings for the receiver by
following the instructions on the Easy Setup screen.
Select your language
Select the language of messages on the screen.
Speaker Settings
Check your speaker system and perform automatic calibration according to the configuration
and arrangement of your speaker system.
Internet Settings
Off
[SLEEP] lights up on the display panel of the receiver when sleep timer is being used.
Select the input for which you want to check information.
1
Press DISPLAY MODE on the receiver repeatedly.
Each time you press DISPLAY MODE, the display will change cyclically as follows:
Index name of the input (*1) - Input you selected - Sound field currently applied (*2) -
Volume level - Stream information (*3)
When listening to FM radio
Preset station name (*1) - Frequency - Sound field currently applied (*2) - Volume level
When receiving RDS broadcasts (for European and Oceanian models only)
Program service name or preset station name (*1) - Frequency, band and preset number -
Sound field currently applied (*2) - Volume level
2
Index name appears only when you have assigned one to the input or preset station. Index name does not
appear if only blank spaces have been entered or it is same as the input name.
*1
[PURE.DIRECT] appears on the display panel when the Pure Direct function is activated.
*2
Stream information may not be displayed.
*3
