62
GB
6
Press
V
/
v
repeatedly to select
“NAME IN”.
7
Press
or
b
to enter the
parameter.
The cursor flashes and you can select a
character. Follow the procedure given in
“To create an index name” below.
To create an index name
1
Use
V
/
v
/
B
/
b
to create an index name.
Press
V
/
v
to select a character, then press
B
/
b
to move the cursor to the next position.
If you made a mistake
Press
B
/
b
until the character you want to
change flashes, then press
V
/
v
to select the
correct character.
Tips
• You can select the character type as follows by
pressing
V
/
v
.
Alphabet (upper case)
t
Numbers
t
Symbols
• To enter a blank space, you can
– press
V
/
v
repeatedly until a blank space
appears in the display.
– press
b
without input a character.
2
Press .
The entered name is registered.
Switching the audio input
mode
(INPUT MODE)
You can select the audio input mode by setting
the audio input mode when you connect
components to both digital and analog audio
input jacks on the receiver.
1
Turn INPUT SELECTOR on the
receiver to select the input.
You can also use the input buttons on the
remote.
2
Press INPUT MODE repeatedly
on the receiver to select the
audio input mode.
The selected audio input mode appears on
the display.
Audio input modes
• AUTO IN
Gives priority to digital audio signals when
there are both digital and analog
connections. If there are no digital audio
signals, analog audio signals are selected.
• COAX IN
Specifies the digital audio signals input to
the DIGITAL COAXIAL jack.
• OPT IN
Specifies the digital audio signals input to
the DIGITAL OPTICAL jack.
• ANALOG
Specifies the analog audio signals input to
the AUDIO IN (L/R) jacks.
Note
Some audio input modes may not be set up
depending on the input.
Other Operations
