1-14(E)
SX-M700
26
Troubleshooting Guide
Should a problem arise in your system, check the system while referring to the
instructions in the table below. If the system continues to malfunction after
applying the following checks and remedies, contact your nearest Sony dealer.
The system indicates the problem by lighting the microphone indicator and MIC
ON/OFF button of chairman’s/delegate’s units.
The indicator and button
blink for a few seconds
when the POWER switch
of the control unit is set
to ON.
The chairman’s unit/
delegate’s units for a
simultaneous
interpretation conference
system, SX-C700A/
D700A/C750/D750, and
those for a conference
system, SX-C100A/
D100A/C150/D150, have
been connected.
To configure the simultaneous conference system, use only
SX-C700A/D700A/C750/D750 units.
The SX-C100A/D100A/C150/D150 can be used. However,
the simultaneous interpretation cannot be heard.
Possible cause
Remedies
Lighting of the
microphone indicator
and MIC ON/OFF button
of the chairman’s unit/
delegate’s unit
The indicator and button
of the chairman’s/
delegate’s units continue
to blink, after the power
switch of the control unit
is set to ON.
The units whose
indicator and button are
blinking cannot be
controlled by the control
unit and cannot be used
in this system.
• When the indicator and button of units subsequent to the
16th unit of the units connected to one DELEGATE’S/
CHAIRMAN’S connector of the control unit blink:
– More than 16 units cannot be connected to one
DELEGATE’S/CHAIRMAN’S connector in series.
Disconnect the 16th unit and subsequent units.
• Even though the number of connected units is less than
16, the indicators of some of the connected units blink:
– The first unit whose indicator and button are blinking
may be defective, or the connecting cable may be
broken.
Disconnect the first unit of those whose indicator and
button are blinking. When the indicator and button of the
subsequent units stop blinking and go out, it indicates
that the disconnected unit was defective. Remove it from
the system or replace it with a functioning unit.
When the indicator and button continue to blink even
after removing the first unit, the connecting cable is
probably broken. Replace the connecting cable linking
the first unit whose indicator and button are blinking and
the unit immediately prior to that unit.
• Even though the number of connected units is less than
16, the indicator and button of some of the connected units
blink:
– The unit whose indicator and button blink is defective.
Disconnect it from the system or replace it with a
functioning unit.
Briefly turn the power off, then back on again.
If the unit subsequently operates normally, communication is
resumed.
If this problem occurs frequently, contact your nearest Sony
dealer.
If the indicator and button continue to blink just after the
power is turned on again, a problem described above may
have occurred. Proceed as described above.
A communication error
has occurred.
After the unit has been
operated for a while after
the power is turned on,
the unit’s indicator and
button start blinking and
do not go out, even after
a few seconds.
(Continued)
27
Possible cause
Remedies
The earphone may be
disconnected.
Insert the earphone plug into the earphone jack surely.
The volume of the
earphone cannot be
adjusted by using the
VOL control.
The earphone may be
disconnected.
Insert the earphone plug into the earphone jack surely.
Lighting of the
microphone indicator
and MIC ON/OFF button
of the chairman’s unit/
delegate’s unit
The channel of the
language to be
monitored cannot be
selected by the CH
selector.
• The mode is that
where the number of
speakers is limited.
• The PRIORITY button
is held down by the
chairman.
• Wait until the speaker finishes speaking. Press the MIC
ON/OFF button again.
• Wait until the chairman releases the PRIORITY button.
The indicator and button
blink and the microphone
is disabled even if the
MIC ON/OFF button is
pressed.
Summary of Contents for SX-M100
