TA-DA9000ES
35
35
Note on Printed Wiring Board:
•
X
: parts extracted from the component side.
•
Y
: parts extracted from the conductor side.
•
x
: parts mounted on the conductor side.
•
a
: Through hole.
•
f
: internal component.
•
: Pattern from the side which enables seeing.
(The other layers' patterns are not indicated.)
Caution:
Pattern face side:
Parts on the pattern face side seen from
(Conductor Side)
the pattern face are indicated.
Parts face side:
Parts on the parts face side seen from
(Component Side)
the parts face are indicated.
6-13. NOTE FOR PRINTED WIRING BOARDS AND SCHEMATIC DIAGRAMS
C
B
These are omitted.
E
Q
B
These are omitted.
C
E
Q
B
These are omitted.
C
E
Q
• Indication of transistor
Note on Schematic Diagram:
• All capacitors are in
µ
F unless otherwise noted. pF:
µµ
F
50 WV or less are not indicated except for electrolytics
and tantalums.
• All resistors are in
Ω
and
1
/
4
W or less unless otherwise
specified.
•
f
: internal component.
•
5
: fusible resistor.
•
2
: nonflammable resistor.
•
C
: panel designation.
•
A
: B+ Line.
•
B
: B– Line.
•
H
: adjustment for repair.
• Voltages are dc with respect to ground under no-signal
(detuned) conditions.
no mark : TUNER
(
) : VIDEO 1 mode
• Voltages are taken with a VOM (Input impedance 10 M
Ω
).
Voltage variations may be noted due to normal produc-
tion tolerances.
• Signal path.
F
: AUDIO (ANALOG)
J
: AUDIO (DIGITAL)
E
: VIDEO
• Abbreviation
KR
: Korean model
TW
: Taiwan model
• DIGITAL, AMP, FCOIL, RCOIL, I. LINK, F. VIDEO, IR and
S. F boards are multi-layer printed board.
However, the patterns of intermediate layers have not
been included in this diagrams.
• Circuit Boards Location
I. LINK board
DIGITAL board
S. F board
VOL board
VOL. LED board
FUNC board
F. VIDEO board
DISP board
H. P board
IR board
POWER board
FSP board
DC board
COMPONENT board
AC board
RSP board
S-VIDEO board
VIDEO board
SUB board
MAIN board
PREOUT board
MOTHER board
RCOIL board
AMP board
FCOIL board
CSP board
Note: The components identified by mark
0
or dotted line
with mark
0
are critical for safety.
Replace only with part number specified.
