4
EN
3-856-686-31(1)
Getting Started
Unpacking
Check that you received the following items:
• Audio connecting cords (2)
Hooking Up the System
This section describes how to hook up the tape deck to
an amplifier. Be sure to turn off the power of each
component before making the connections.
Getting Started
TC-WE305
to LINE OUT
to an AC
outlet
to LINE IN
Amplifier
to TAPE IN
to REC OUT
to a
wall outlet
Hookups
When connecting an audio connecting cord, be sure to
match the color-coded cord to the appropriate jacks on
the components: Red (right) to Red and White (left) to
White. Be sure to make connections firmly to avoid
hum and noise.
Connect the tape deck to the amplifier as shown below.
LINE
ç
OUT
IN
L
R
Ç
TAPE
L
R
IN
L
R
REC OUT
ç
: Signal flow
Tape deck
Amplifier
Setting the voltage selector (only on
models supplied with a voltage selector)
Check that the voltage selector on the rear panel of the
tape deck is set to the local power line voltage. If not,
set the selector to the correct position using a
screwdriver before connecting the AC power cord to
an AC outlet.
Connecting the AC power cord
Connect the AC power cord to an AC outlet.
2 4 0 V
2 2 0 V
1 2 0 V
1 1 0 V
V O L T A G E
