— 34 —
KV-29SL40T / 29VL40T / 29XL40T
H. CENTER ADJUSTMENT (HPOS)
Note : Perform this adjustment after checking H. FREQUENCY.
1. Input a cross-hatch signal.
2. Set the Service adjustment Mode.
3. Select HPOS with
and
.
4. Adjust with
and
for the best horizontal center.
5. Write into the memory by pressing
then
V. LINEARITY (VLIN) AND V CORRECTION
1. Input a cross-hatch signal.
2. V. Correction is automatically adjusted from the circuit and
should satisfy the conditions below:
SERVICE ADJUSTMENT MODE MEMORY
1. Change DCOL to "1".
2. After completing all adjustments, press "0" then
.
/
/
V. SIZE (VSIZ)
SUB BRIGHT ADJUSTMENT (SBRT)
1. Input a cross-hatch signal.
2. Set to Service adjustment Mode.
3. Set the PICTURE and BRIGHT to minimum.
4. Select SBRT with
and
.
5. Adjust with and
to obtain a faintly visible cross-hatch.
6. Write into the memory by pressing
then
.
SUB HUE, SUB COLOR ADJUSTMENT (SHUE, SCOL)
1. Input a color-bar signal.
2. Set to Service adjustment Mode.
3. Select the item DCOL and set to "0" level.
4. Connect oscilloscope probe to CV Board, CN1702 Pin
7
(B OUT) for KV-29Vl40T or C Board CN1752 Pin
5
(B
OUT) for KV-29SL40T/29XL40T.
5. Select SHUE and SCOL with and
.
6. Adjust with and
for the V1 = V4
±
0.1Vp-p (SCOL)
and V2 = V3
±
0.1Vp-p (SHUE).
V1
V2
V3
V4
7. Reset the item DCOL to "1" level.
8. Write into the memory by pressing
then
.
V. SIZE ADJUSTMENT ( VSIZ)
1. Input a cross-hatch signal.
2. Set to Service adjustment mode.
3. Select VSIZ with
and .
4. Adjust with and
for the best vertical size.
V. CENTER ADJUSTMENT (VPOS)
1.Input a cross-hatch signal.
2.Set to Service adjustment Mode.
3.Select VPOS with
and
.
4.Adjust with
and
for the best vertical center.
5.Write into the memory by pressing
then
/
?
H. CENTER (VPOS)
/
?
V. CENTER (VPOS)
READ FROM MEMORY
Green
0
SERVICE
READ
Red
