22
Cushion
8 Coil Demagnetic
9 Spring Extension
6 Chassis
1 Two screws
2 Speaker
15 Picture tube
2-8. PICTURE TUBE REMOVAL
Anode button
a
* REMOVING PROCEDURES.
Turn up one side of the rubber cap in
the direction indicated by the arrow a
1
2 Using a thumb pull up the rubber cap
firmly in the direction indicated by the
arrow b
3 When one side of the rubber cap is
separated from the anode button, the
anode-cap can be removed by turning
up the rubber cap and pulling it up in
the direction of the arrow c
b
b
c
Note : Short circuit the anode of the picture tube and the anode cap to the metal chassis, CRT
shield or carbon paint on the CRT, after removing the anode.
• REMOVAL OF ANODE-CAP
•
HOW TO HANDLE THE ANODE-CAP
1
To prevent damaging the surface of the anode-cap do not use sharp materials.
2
Do not apply too great a pressure on the rubber, as this may cause damage to the
anode connector.
3
A metal fitting called a shatter hook terminal is fitted inside the rubber cap.
Do not turn the rubber foot over excessively this may cause damage if the shatter
hook sticks out.
11 VM board
10 C board
12 Neck assy
13 Deflection
yolk
4 Speaker
5 Anode cap
7 DGC holders
14 Four Tapping
Screws (m)
3 Two screws
Summary of Contents for TRINITRON KV-32WS2B
