Sony TRINITRON KV-32WS2B, Service Manual

5

TABLE OF CONTENTS

CAUTION

SHORT CIRCUIT THE ANODE OF THE PICTURE TUBE AND THE
ANODE CAP TO THE METAL CHASSIS, CRT SHIELD, OR THE
CARBON PAINTED ON THE CRT, AFTER REMOVAL OF THE
ANODE CAP

WARNING !!

AN ISOLATING TRANSFORMER SHOULD BE USED DURING ANY
SERVICE WORK TO AVOID POSSIBLE SHOCK HAZARD DUE TO
LIVE CHASSIS. THE CHASSIS OF THIS RECEIVER IS DIRECTLY
CONNECTED TO THE POWER LINE.

SAFETY-RELATED COMPONENT WARNING !!

COMPONENTS IDENTIFIED BY SHADING AND MARKED

ON

THE SCHEMATIC DIAGRAMS, EXPLODED VIEWS AND IN THE
PARTS LIST ARE CRITICAL FOR SAFE  OPERATION. REPLACE
THESE COMPONENTS WITH SONY PARTS WHOSE PART NUMBERS
APPEAR AS SHOWN IN THIS MANUAL OR IN SUPPLEMENTS 
PUBLISHED BY SONY.

ATTENTION

APRES AVOIR DECONNECTE LE CAP DE’LANODE,
COURT-CIRCUITER L’ANODE DU TUBE CATHODIQUE ET
CELUI DE L’ANODE DU CAP AU CHASSIS METALLIQUE
DE L’APPAREIL, OU AU COUCHE DE CARBONE PEINTE
SUR LE TUBE CATHODIQUE OU AU BLINDAGE DU TUBE
CATHODIQUE.

ATTENTION !!

AFIN D’EVITER TOUT RISQUE D’ELECTROCUTION PROVENANT
D’UN CHÁSSIS SOUS TENTION, UN TRANSFORMATEUR
D’ISOLEMENT DOIT ETRE UTILISÈ LORS DE TOUT DÈPANNAGE.
LE CHÁSSIS DE CE RÈCEPTEUR EST DIRECTMENT RACCORDÈ
Á L’ALIMENTATION SECTEUR.

ATTENTION AUX COMPOSANTS RELATIFS  Á LA

SÈCURITÈ  !!

LES COMPOSANTS IDENTIFIÈS PAR UNE TRAME ET PAR UNE 

MARQUE

SUR LES SCHÈMAS DE PRINCIPE, LES VUES 

EXPLOSÈES ET LES LISTES DE PIECES SONT D’UNE IMPORTANCE
CRITIQUE POUR LA SÈCURITÈ DU FONCTIONNEMENT, NE LES
REMPLACER QUE PAR DES COMPSANTS SONY DONT LE NUMÈRO
DE PIÈCE EST INDIQUÈ DANS LE  PRÈSENT MANUEL OU DANS
DES SUPPLÈMENTS PUBLIÈS PAR SONY.

Section

Title

Page

Section

Title

Page

1. GENERAL

Overview

.....................6

Getting Started

.....................8

TV Operation

.....................9

Advanced Operations

.....................10

Teletext

.....................16

Optional Equipment

.....................17

Troubleshooting

.....................19

2. DISASSEMBLY

2-1.

Rear Cover Removal

.....................20

2-2.

Speaker Removal

.....................20

2-3.

Chassis Assy Removal

.....................20

2-4-1. Service Position (1)

.....................20

2-4-2. Service Position (2)

.....................21

2-5.

A Board Removal

.....................21

2-6.

A Extension Board 

.....................21

2-7.

A1 Extension boards

.....................21

2-8.

Picture Tube Removal

.....................22

Removal of Anode Cap

.....................22

Removal and Replacement of the 
Main - Bracket Bottom Plates

.....................23

3.  SET-UP ADJUSTMENTS

3-1.

Beam Landing

.....................24

3-2.

Convergence

.....................25                                                                                                                                                                                                                                                                                                                                                                                                                                                                                                                                                                                                                                                                                                                                                                                                                                                                                                                                                                                                                                                                                                                                                                                                                                                                                                                                                                                                                                                                                                                                                                                                                                                                                                                                                                                                                                                                                                                                                                                                                                                                                                                                                                                                                                                                                                                                                                                                                                                                                                                                                                                                                                                                                                                                                                                                                                                                                                                                                                                                                                                                                                                                                                                                                                                                                                                                                                                                                                                                                                                                                                                                                                                                                                                                                                                                                                                                                                                                                                                                                                                                                                                                                                                                                                                                                                                                                                                                                                                                                                                                                                                                                                                                                                                                         

3-3.

White Balance

.....................27

4.  CIRCUIT ADJUSTMENTS

4-1.

Electrical Adjustments

.....................28

4-2.

Test Mode 2

.....................31

4-3.

BE-3D Self Diagnostic Software

.....................33

5.  DIAGRAMS

5-1.

Block Diagrams

.....................35

5-2.

Circuit Board Location

.....................43

5-3.

Schematic Diagrams and
Printed Wiring Boards

.....................43

*

K1 Board

.....................44

*

D Board

.....................51

*

A Board

.....................56

*

C Board

.....................66

*

VM Board

.....................67

*

A1 Board

.....................71

*

J Board

.....................72

*

D4 Board

.....................74

*

IF Board
[VIF (AEP), VIF UK]

.....................77

*

IF Board [VIF (FR)]

.....................77

IC Blocks

.....................79

5-4.

Semiconductors

.....................81

6.  EXPLODED VIEWS

6-1.

Chassis

.....................83

6-2.

Picture Tube

.....................84

7.  ELECTRICAL PARTS LIST

.....................85