– 12 –
KV
-G21PD1
RM-883
2-6. PICTURE TUBE REMOVAL
•
REMOVAL OF ANODE-CAP
NOTE : After removing the anode short circuit the anode of the picture tube and
the anode cap to the metal chassis, CRT shield or carbon paint on the
CRT.
•
REMOVING PROCEDURES
1
Turn up one side of the rubber cap in the direction indicated by the arrow
a
.
2
Using a thumb press down then pull up the rubber cap firmly in the direction
indicated by the arrow
b
.
3
When one side of the rubber cap is separated from the anode button, the
anode-cap can be removed by turning up the rubber cap and pulling it up in the
direction of the arrow
c
.
•
HOW TO HANDLE AN ANODE-CAP
1
Do not damage the surface of anode-caps with sharp shaped objects
2
Do not press the rubber too hard so as not to damage the inside of anode-caps
A metal fitting called the shatter-hook terminal is built into the rubber.
3
Do not turn the foot of rubber over too hard
The shatter-hook terminal will stick out or damage the rubber.
2
A board
3
C board
4
Deflection yoke
Cushion
5
Four screws
(Tapping screws)
1
Anode cap
a
a
b
b
c
Anode button
