–
12
–
KV
-HA14M80
RM-969
•
REMOVAL OF ANODE-CAP
NOTE : After removing the anode, short circuit the anode of the picture tube and
the anode cap to the metal chassis, CRT shield or carbon paint on the
CRT.
•
REMOVING PROCEDURES
1
Turn up one side of the rubber cap in the direction indicated by the arrow
a
.
2
Using a thumb pull up the rubber cap firmly in the direction indicated by the arrow
b
.
3
When one side of the rubber cap is separated from the anode button, the anode-cap
can be removed by turning up the rubber cap and pulling it up in the direction of the
arrow
c
.
•
HOW TO HANDLE AN ANODE-CAP
1
Do not damage the surface of anode-caps with sharp shaped objects.
2
Do not press the rubber too hard so as not to damage the inside of anode-cap.
A metal fitting called the shatter-hook terminal is built into the rubber.
3
Do not turn the foot of rubber over too hard.
The shatter-hook terminal will stick out or damage the rubber.
a
a
b
b
c
Anode Button
!¢
!¢
!£
Demagnetic coil
4
Two screws, step tapping
5
Speaker
(12
×
5cm)
3
Speaker
(12
×
5cm)
9
Tension
spring
!™
Chassis assy
!º
Deflection
yoke
!¡
C board
8
Anode cap
Coating earth assy
!§
Picture tube
1
Cushion
6
Two screws (5)
tapping
7
Two screws (5)
tapping
2
Two screws, step tapping
!∞
Holder DGC
Cushion DGC
Cushion DGC
Beznet Hook
Two screws
(+BVTP 4x16)
PWB Bracket
CRT Support Block
CRT Support Block
2-7. PICTURE TUBE REMOVAL
Note:
•
Please make sure the TV set is not in standing position before removing necessary
CRT support located on bottom right and left.
