– 8 –
KV-PG21P10
RM-952
!
PROGR
SELECT
6
1
3
7
2
5
qa
qs
8
4
9
0
E
Connecting optional components
Connecting to the video input terminal (
t
)
TV front panel
Camcorder
Audio/Video cable
(not supplied)
Note
• Do not connect video equipment to
t
(video input) at the front and the rear of your TV at
the same time; otherwise the picture will not be displayed properly on the screen.
TV rear panel
Audio/Video cable
(not supplied)
Connecting to the monitor output terminal (
T
)
VCR
video game
equipment
VCR
Audio system
Audio/Video cable
(not supplied)
TV rear panel
D
TV front and rear panels
TV front panel
TV rear panel
Button
Function
1
!
Turn off completely or turn on the TV.
2
Remote control sensor.
3
1
Standby indicator.
3
Wake Up indicator.
4
PROGR +/–
Select program number.
5
2
+/– *
Adjust volume.
6
t
Select TV or video input.
7
SELECT
Select the desired item.
8
Earphone terminal.
9
,
qa
t
Video input terminal.
0
8
Antenna terminal.
qs
T
Monitor output terminal.
* You can also use the
2
+/– buttons on the TV to work as the +/– buttons on the remote.
Power requirements
220-240 V AC, 50/60 Hz
Power consumption (W)
Indicated on the rear of the TV
Television system
B/G
Color system
PAL, PAL 60, NTSC3.58 (AV IN), NTSC4.43
Channel coverage
VHF: E2 to E12
UHF: E21 to E69
CATV: S01 to S03, S1 to S41
VHF: 0 to 12, 5A, 19A
Australia only
UHF: 28 to 69
CATV: S01 to S03, S1 to S41
VHF: 1 to 11
New Zealand only
UHF: 21 to 69
CATV: S01 to S03, S1 to S41
8
(Antenna)
75-ohm external terminal
Audio output (Speaker)
3W
Number of terminal
(Video)
Input: 2
*
Output: 1
Phono jacks; 1 Vp-p, 75 ohms
*
One input line
available
(Audio)
Input: 2
*
Output: 1
Phono jacks; 500 mVrms
*
One input line
available
(Earphone)
Output: 1
Monaural minijack
Picture tube
14 in.
21 in.
Tube size (cm)
37
54
Measured diagonally
Screen size (cm)
34
51
Measured diagonally
Dimensions (w/h/d, mm)
375 x 346 x 411
497 x 458 x 487
Mass (kg)
12
25
G
Specifications
Design and specifications are subject to change without notice.
Note
KV-PG14P10
KV-PG21P10
F
Troubleshooting
If you find any problem while viewing your TV, please check the following
guide. If any problem persists, contact your Sony dealer.
Snowy picture,
noisy sound
No picture, no sound
Good picture, no sound
Dotted lines or stripes
Double images or
“ghosts”
No color
Abnormal color
patches
The
1
(standby)
indicator on your TV
flashes red several
times after every
three seconds.
TV cabinet creaks.
A "boom" sound is
heard when the TV is
turned on.
Symptom
Solutions
• Check the antenna cable and connection on the TV, VCR and on the wall.
• Preset the channel manually again. (See
J
)
• Check the antenna setup. Contact a Sony dealer for advice.
• Check the power cord, antenna and the VCR connections.
• Press
?
/
1
(power) or
!
(main power) to turn on the TV.
• Press
2
+ to increase the volume level.
• Press
%
to cancel the muting.
• Do not use a hair dryer or other equipment near the TV.
• Check the antenna setup. Contact a Sony dealer for advice.
• Use the fine tuning ("FINE") function.
• Turn off or disconnect the booster if it is in use.
• Check the antenna setup. Contact a Sony dealer for advice.
• Select the appropriate color system. (See
J
)
• Adjust the color level.
• Check the antenna setup. Contact a Sony dealer for advice.
• Keep external speakers or other electrical equipment away from the TV.
Press
!
(main power) to turn off the TV for about 15 minutes, then turn
it on again to demagnetize the TV.
• Count the number of times the
1
(standby) indicator flashes. Press
!
(main power) to turn off your TV. Contact your nearest Sony service
center.
• Changes in room temperature sometimes make the TV cabinet expand or
contract, making a noise. This does not indicate a malfunction.
• The TV's demagnetizing function is working. This does not indicate a
malfunction.
Summary of Contents for TRINITRON KV-PG21P10
Page 24: ... 24 KV PG21P10 RM 952 MEMO ...
