4
This product has been manufactured by or on
behalf of Sony Corporation.
EU Importer: Sony Europe Limited.
Inquiries to the EU Importer or related to product
compliance in Europe should be sent to the
manufacturer’s authorized representative, Sony
Belgium, bijkantoor van Sony Europe Limited,
Da Vincilaan 7-D1, 1935 Zaventem, Belgium.
Notice for the customers in Europe
Hereby, Sony Corporation declares that this
equipment is in compliance with Directive
2014/53/EU.
The full text of the EU declaration of conformity
is available at the following internet address:
http://www.compliance.sony.de/
PRECAUTIONS
• This unit operates on 220 V - 240 V AC,
50/60 Hz. Check that the unit’s operating
voltage is identical with your local power
supply.
• Install this unit so that the AC power cord
(mains lead) can be unplugged from the
wall socket immediately in the event of
trouble.
• This equipment has been tested and found
to comply with the limits set out in the EMC
Regulation using a connection cable shorter
than 3 metres.
• Place the player in a location with adequate
ventilation to prevent heat build-up in the
player.
• To reduce the risk of fire, do not cover the
ventilation opening of the appliance with
newspapers, tablecloths, curtains, etc.
• Do not expose the appliance to naked flame
sources (for example, lighted candles).
• Do not install this player in a confined
space, such as a bookshelf or similar unit.
• Do not place the player outdoors, in
vehicles, on ships, or on other vessels.
• If the player is brought directly from a cold
to a warm location, or is placed in a very
damp room, moisture may condense on the
lenses inside the player. Should this occur,
the player may not operate properly. In this
case, remove the disc and leave the player
turned on for about half an hour until the
moisture evaporates.
• Do not install the player in an inclined
position. It is designed to be operated in a
horizontal position only.
• Do not place metal objects in front of the
front panel. It may limit reception of radio
waves.
• Do not place the player in a place where
medical equipment is in use. It may cause a
malfunction of medical instruments.
• This player should be installed and
operated with a minimum distance of at
least 20 cm or more between the player and
a person’s body (excluding extremities:
hands, wrists, feet and ankles).
• Do not place heavy or unstable objects on
the player.
• Do not place any objects other than discs on
the disc tray. Doing so may cause damage
to the player or the object.
• Take out any discs from the tray when you
move the player. If you don’t, the disc may
be damaged.
• Disconnect the AC power cord (mains lead)
and all other cables from the player when
you move the player.
• The AC power cord (mains lead) is not
disconnected from the mains as long as it is
connected to the AC outlet, even if the
player itself has been turned off.
• Disconnect the player from the wall outlet if
you are not going to use the player for a
long time. To disconnect the AC power cord
(mains lead), grasp the plug itself; never
pull the cord.
• Observe following points to prevent the AC
power cord (mains lead) being damaged.
Do not use the AC power cord (mains lead)
if it is damaged, as doing so may result in an
electric shock or fire.
– Do not pinch the AC power cord (mains
lead) between the player and wall, shelf,
etc.
– Do not put anything heavy on the AC
power cord (mains lead) or pull on the AC
power cord (mains lead) itself.
• Use the supplied AC adaptor for this player,
as other adaptors may cause a malfunction.
• Do not disassemble or reverse-engineer the
AC adaptor.
• Do not confine the AC adaptor in a closed
place such as a bookshelf or an AV cabinet.
• Do not connect the AC adaptor to a
traveler’s electric transformer, which may
generate heat and cause a malfunction.
• Do not drop or apply shock to the AC
adaptor.
