COIN MECHANISM
Refer to Figs. 1, 2 and 3
THICKNESS
To adjust the thickness setting, first release the setting screw locknuts. Place a true coin on a track and adjust the
thickness setting to a point where the coin just starts to fall through the coin track at both ends of the track. Before
tightening the locknuts, the screws should be withdrawn just sufficient to allow the good coin to ride on the edge of
the track at the fixed side.
DIAMETER
The diameter setting is adjusted by moving the slider. Release the slider fixing screws, and with a true coin, adjust
the slider so that it is parallel to the base of the coin track, and just stops the coin from falling out of the side of the
run down. Check this at both ends of the track, and if correct, re-tighten the fixing screws. Check both settings
using new and well-worn coins of the correct denomination, and check for rejection of incorrect coins and any
problem blanks.
MICROSWITCH
The microswitch accept chute is adjustable to one of four widths. This is factory adjusted to the correct diameter
and should not require field adjustment.
The microswitch actuating wire should not catch on the side of the black plastic microswitch bracket. At its resting
position, the wire should run along the mid point of a small ridge in the bracket.
The microswitch is available in three different spring tensions - identified by the colour of the plastic boss at the
wires pivot point.
Red:
Light tension e.g. 1 Aus. Sch. 25c NL.
Black:
Medium tension e.g. 2p and other intermediate coins.
White:
Heavy tension e.g. 10p, 10p 5DM.
For security reasons, the microswitch with the heaviest tension which still allows the coin to pass is fitted.
Finally, check that the interlock hangs freely as this prevents the coin-on-cotton fiddle.
IF THE ABOVE PROCEDURES ARE NOT SUCCESSFUL, CHECK FOR WORN OR DAMAGED
PARTS AND REPLACE WHERE NECESSARY.
LOCK OUT COILS
Voltage Current Power Colour
Code
240V AC
30.0 mA
7.2 VA
White + Blue
110V AC
42.0 mA
4.62 VA
White + Green
50V AC
76.5 mA
3.8 VA
White + Red
24V AC
240.0 mA
5.76 VA
White + Yellow
12V AC
240.0 mA
2.88 VA
White + Grey
24V DC
300.0 mA
7.2 W
Black + Yellow Band
12V DC
350.0 mA
4.2 W
Black + Grey/Blue Band
10V DC
300.0 mA
3.2 W
Black + Brown
