1-7
UP
A-D3 (UC, CED)
Power requirements
Model for use in the USA and Canada: 100 VAC
to 120 V AC, 50/60 Hz
European model: 220 VAC to 240 VAC, 50/60Hz
Power consumption
Model for use in the USA and Canada: Max. 1.0 A
European model: Max. 0.6 A
Operating temperature
8˚ to 35˚C (46˚ to 95˚F)
Storage temperature
-20˚ to 60˚C (-4˚ to 140˚F)
Operating humidity
20% to 80% (no condensation allowed)
Storage and transport humidity 20% to 80% (no condensation allowed)
Dimensions
About 424
×
69
×
300.5 mm (w/h/d)
(16
3
/
4
×
2
3
/
4
×
11
7
/
8
inches)
excluding the projecting parts.
Mass
About 5 kg (11 lb)
Interface
SERIAL connector: conforming to RS-232C
(D-SUB 25 pin)
×
1
Data communication speed: 9600 bps
Parity: None
Data bit: 8
Stop bit: 1
Input: Max. ±25 V
Output: Max. ±10 V
SCSI connector: SCSI-2 (50-pin half-pitch)
×
1,
Logic level TTL
NETWORK connectors: 10 BASE-T/10 BASE-5
one for each
10BASE-5 Output: 12V
Input/output
AC IN for AC power input
Supplied accessories
AC power cord (1)
Instructions for use (1)
Design and specifications are subject to change without notice.
Others
Specifications
Others
12
Troubleshooting
If a problem occurs, first check the following troubleshooting guide and follow
instructions to solve the problem. If the problem persists, switch off the digital
image processor and call your Sony dealer.
Symptom
Possible causes and remedies
• The power switch of the digital image processor is pushed
too soon after the AC plug is inserted into the wall outlet.
→
Wait 10 seconds and set the power switch to ON again.
• The POWER switch was not pushed and held long enough.
→
Press and hold the POWER switch down about two
seconds until the POWER lamp lights.
• The power has been switched on again too soon after it was
switched off.
→
Wait 30 seconds, then switch on power again.
• Connections may not be correct.
→
Make sure connections are correct.
Power does not switch on
when you press and hold
the POWER switch.
Data is not sent to the
printer.
The SCSI address is not correctly set.
→
0 or 7 is used. Set SCSI address to one of 1 to 6.
Unit operation is unstable.
The total cable length is too long.
→
Insert a SCSI booster between the unit and printers.
Others
13
