Using Your Notebook Computer
Connecting a Power Source
Sony
Not
e
book
Com
p
ut
er
Us
er
Gui
d
e
18
Using Battery Power
You can use a battery pack as a source of power.
The battery pack supplied with your computer is not fully charged at the time of
purchase. Follow the steps below to insert and charge the battery pack.
To insert the battery pack
1
Move the lock lever on the bottom of the computer to the UNLOCK position.
2
Align the grooves and tabs on the battery with the tabs and notches on the back of
the computer, and then slide the battery towards the computer until it clicks into
place.
3
Slide the lock lever into the
LOCK
position to secure the battery on the computer.
!
You may lose data if you
remove the battery pack while
the computer is on and not
connected to the AC adapter
or if you remove the battery
while the computer is in
system suspend mode.
You can remove the battery
pack without turning off the
computer when it is connected
to the mains voltage (AC
adapter).
Before you remove / insert the
battery pack, close the cover.
Battery lock lever
Battery pack
Grooves
