15
GB
Specifications
Specifications
Projection system
3 LCD panels, 1 lens, primary
color shutter system
LCD panel
0.79-inch XGA panel, 2,359,296
pixels (1024
×
768 × 3)
Lens
1.2 times zoom lens
Lamp
200 W Ultra high pressure lamp
Projected picture size
40 to 300-inches (measured
diagonally)
Light output
VPL-CX150/CX155: 3500 lm
VPL-CX120/CX125: 3000 lm
VPL-CX100: 2700 lm
(When the Lamp Mode is set to
“High.”)
Throwing distance (When placed on the floor.)
When an XGA signal is input
40-inch: 1.2 to 1.4 m
(3.9 to 4.6 feet)
60-inch: 1.8 to 2.1 m
(5.9 to 6.9 feet)
80-inch: 2.4 to 2.8 m
(7.9 to 9.2 feet)
100-inch: 3.0 to 3.5 m
(9.8 to 11.5 feet)
120-inch: 3.6 to 4.1 m
(11.8 to 13.5 feet)
150-inch: 4.5 to 5.2 m
(14.8 to 17.1 feet)
180-inch: 5.4 to 6.2 m
(17.7 to 20.3 feet)
200-inch: 6.0 to 6.9 m
(19.7 to 22.6 feet)
250-inch: 7.5 to 8.7 m
(24.6 to28.5 feet)
300-inch: 9.1 to 10.4 m
(29.9 to 34.1 feet)
There may be a slight difference between the
actual value and the design value shown above.
Color system NTSC
3.58
/PAL/SECAM/
NTSC
4.43
/PAL-M/PAL-N/
PAL60 system, switched
automatically/manually
Acceptable computer signals
fH: 19 to 92 kHz
fV: 48 to 92 Hz
(Maximum input resolution
signals: SXGA+ 1,400
×
1,050
fV: 60Hz)
Applicable video signals
15 k RGB/Component 50/60 Hz,
Progressive component 50/60
Hz, DTV (480/60i, 575/50i,
480/60p, 575/50p, 720/60p,
720/50p, 1080/60i, 1080/50i),
Composite video, Y/C video
Dimensions
372 × 90 × 298 mm (14
3
/
4
× 3
5
/
8
× 11
3
/
4
inches) (w/h/d)
(without the projection parts)
Mass
Approx. 4.1 kg (9 lb 1 oz)
Power requirements
AC 100 to 240 V, 2.9 - 1.2 A, 50/
60 Hz
Power consumption
Max. 285 W
(in standby (standard): 7 W, in
standby (low): 0.5 W)
Supplied accessories
Remote Commander (1)
Size AA (R6) batteries (2) (VPL-
CX125/CX155)
Lithium battery CR2025 (1) (VPL-
CX100/CX120/CX150)
Lens cap (1)
HD D-sub 15 pin cable (2 m) (1)
(1-791-992-xx)
AC power cord (1)
CD-ROM (Operating Instructions,
Application Software) (1)
Quick Reference Manual (1)
Safety Regulations (1)
Security Label (1)
Design and specifications are subject to change
without notice.
Always verify that the unit is operating properly
before use. SONY WILL NOT BE LIABLE FOR
DAMAGES OF ANY KIND INCLUDING, BUT
NOT LIMITED TO, COMPENSATION OR
REIMBURSEMENT ON ACCOUNT OF THE
LOSS OF PRESENT OR PROSPECTIVE
PROFITS DUE TO FAILURE OF THIS UNIT,
EITHER DURING THE WARRANTY PERIOD
OR AFTER EXPIRATION OF THE
WARRANTY, OR FOR ANY OTHER REASON
WHATSOEVER.
Optional accessories
Projector Lamp
LMP-C200 (for replacement)
Presentation Tool
RM-PJPK1
Note
