D:\WORK\VW60GB\3275583131\3275583131VPLVW200UC\010GB_
VPLVW200UC\05PRE.fm
masterpage:Left
21
C
o
nne
ct
io
ns
and
P
re
par
at
ions
VPL-VW200
3-275-583-
13
(1)
Tip
Set “Input-A Signal Sel.” in the Setup
menu to “Auto.” If the input signal does not appear
properly, set it to “Computer.” (
• When connecting an HDMI cable, make sure the
V
mark on the upper part of the HDMI
input of the projector and the
V
mark on the connector of the cable is set at the same
position.
• If you set your computer, such as a notebook type, to output the signal to both
computer’s display and this equipment, the picture of the equipment may not appear
properly. Set your computer to output the signal to only the external monitor.
For details, refer to the computer’s operating instructions supplied with your computer.
For settings of the computer, consult with the manufacturer of the computer.
• If the picture from equipment connected to the projector with an HDMI cable is not
clear, check the settings of the connected equipment.
Connecting to a Computer
Notes
HD-Dsub15 pin cable (not supplied) or HDMI cable (not supplied)
: Video signal flow
Right side of the projector
to monitor output
Computer
When using an optional HDMI cable, be sure to use
a cable that has acquired the HDMI logo.
