WARNING
3
GB
When using the product, do not use it for purposes other
than those described in the instruction manual.
WARNING
To reduce the risk of fire or electric shock, do not
expose this apparatus to rain or moisture.
To avoid electrical shock, do not open the
cabinet. Refer servicing to qualified personnel
only.
WARNING
This apparatus must be earthed.
WARNING
When installing the unit, incorporate a readily accessible
disconnect device in the fixed wiring, or connect the power
plug to an easily accessible socket-outlet near the unit. If a
fault should occur during operation of the unit, operate the
disconnect device to switch the power supply off, or
disconnect the power plug.
CAUTION
About the LAN connector
For safety, do not connect the connector for peripheral
device wiring that might have excessive voltage to this
port.
CAUTION
- Danger of explosion if battery is incorrectly replaced.
Replace only with the same or equivalent type
recommended by the manufacturer.
- When you dispose of the battery or the product, you must
obey the law in the corresponding area or country. Do
not dispose of the battery or the product in a fire or a hot
oven, or mechanically crush or cut the battery. It may
explode or cause a fire. Do not subject the battery to
extremely low air pressure that may result in an
explosion or the leakage of flammable liquid or gas.
- Do not place the battery in a high temperature place,
such as under direct sunlight or near fire. It may ignite,
explode, or cause a fire. Do not immerse or wet the
battery in water or seawater. This may cause an electric
shock.
CAUTION
The following size and number of batteries are required for
the remote control.
• Size: AA (R6)
• Number of battery(ies): Two pieces
To avoid risk of explosion, use only the following type of
battery.
• Alkaline or manganese batteries
For the customers in the U.S.A.
This equipment has been tested and found to comply with
the limits for a Class B digital device, pursuant to part 15
of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and
can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause
harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause
harmful interference to radio or television reception, which
can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one
or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and
receiver.
- Connect the equipment into an outlet on a circuit
different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV
technician for help.
You are cautioned that any changes or modifications not
expressly approved in this manual could void your
authority to operate this equipment.
All interface cables used to connect peripherals must be
shielded in order to comply with the limits for a digital
device pursuant to Subpart B of part 15 of FCC Rules.
This device complies with part 15 of the FCC Rules.
Operation is subject to the following two conditions: (1)
This device may not cause harmful interference, and (2)
this device must accept any interference received,
including interference that may cause undesired operation.
If you have any questions about this product, you may call;
Sony Customer Information Service Center 1-800-222-
7669 or http://www.sony.com/
This transmitter must not be co-located or operating in
conjunction with any other antenna or transmitter.
For the customers the U.S.A.
Radiated Exposure Statement:
The product complies with the US portable RF exposure
limit set forth for an uncontrolled environment and is safe
for intended operation as described in this manual. The
further RF exposure reduction can be achieved if the
product can be kept as far as possible from the user body
Supplier’s Declaration of Conformity
Trade Name:
SONY
Model:
VPL-VW790ES
Responsible party:
Sony Electronics Inc.
Address:
16535 Via Esprillo, San Diego, CA
92127 U.S.A.
Telephone Number: 858-942-2230
This device complies with part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) this device must accept any interference received,
including interference that may cause undesired
operation.
English
GB
