15
Replacing the lens
Replacing the lens
1
Turn off the MAIN POWER switch of the projector.
2
Remove the four screws (3 x 8 mm) on the top panel with
a Phillips-head screw driver.
4
Remove the shield case lid.
Remove the cable harness and remove all the plugs from
their connectors in the circuit board (7 plugs in the VPL-
V500Q/QM, S500U/E/M; 8 plugs in the VPL-W400Q/
QM). Also remove the three LCD panel flexible cables
from their connectors.
3
Disconnect the connector of cable (1 plug) running
between the top panel and the circuit board C of the
projector and remove the top panel.
Connectors
(1 for each
place)
Note
Do not touch a tip of the flexible cable.
Connector (1)
Shield case lid
Connectors (3)
Connector (2)
Cable harness
Flexible cables
(3)
Connector
(VPL-W400Q/QM only)