Preparing a Power
Source
Charge the built-in lithium-ion rechargeable
battery before using it for the first time or
when it is depleted.
1
Slide the BUILT-IN BATTERY switch
to ON.
The protection for the built-in
rechargeable battery is released and power
is supplied to the player. Keep the switch
to ON position.
2
Connect the USB cradle to the AC
power adaptor.
Connect the DC plug of the AC power
adaptor to the DC IN jack of the USB
cradle, and then connect the AC plug to a
wall outlet.
to an AC outlet
AC power
adaptor
to DC IN
jack
USB cradle
3
Place the player on the USB cradle.
Insert the player as shown below until it
clicks into place.
Charging of the battery starts. The CHG
lamp lights up on the USB cradle, and if
the player is on, the battery indicator in
the display changes.
USB cradle connector
(on the bottom of the
player)
CHG lamp
USB cradle
Charging is completed and the CHG lamp
goes off in approximately 3 hours*. The
lighting mark lights up in the display if
the player is on. When the player display
is off, it takes approximately 1 hour* to
charge up to 80%.
* This is the approximate charging time for
an empty battery charged under a room
temperature. When the player display is on, it
takes approximately 6 hours to charge up to
80%. The charging time will differ depending
on the remaining power and battery condition.
If the battery is charged in a low-temperature
environment, the charging time will be longer.
8
NW-HD1.US.2-102-806-11(1)
9
Getting Started
NW-HD1.US.2-102-806-11(1)
Summary of Contents for Walkman NW-HD1
