58
Remote C
ontrol
Programming the Remote Control
The remote control is preset to operate Sony brand video equipment.
If you have video equipment other than Sony brand that you want to control
with the TV’s remote control, use the following procedures to program the
remote control.
From the “Manufacturer’s Codes” listed on page 59, select the three-digit
code number for the manufacturer’s code of your equipment. If more than
one code number is listed, try entering them one by one until you come to the
correct code for your equipment. Use the code number to complete the
following procedure.
1
Press the
DVD/VCR (FUNCTION)
and
RESET
buttons
simultaneously, or press the
SAT/CABLE (FUNCTION)
and
RESET
buttons simultaneously. DVD/VCR and SAT/CABLE buttons flash.
2
Press the function button you want to program.
To program a cable box or a satellite receiver
Press
SAT/CABLE (FUNCTION)
.
To program video equipment
Press
DVD/VCR (FUNCTION)
.
3
Enter the three-digit manufacturer’s code number using the
0-9
buttons.
4
Press
ENT
.
5
To check if the code number works, aim the TV’s remote control at the
equipment and press
DVD/VCR
and/or
SAT/CABLE (POWER)
that
corresponds with that equipment. If it responds, the programming is
completed. If not, try using the other codes listed for that manufacturer.
Sony Equipment
Programmable Code Number
DVD/VCR
601 (Sony Dream System)
SAT/Cable
801 (Sony Satellite Receiver)
The equipment must have infrared (IR) remote capability in
order to be used with this remote control.
If you enter a new code number, the code number you
previously entered at that setting is erased.
In some rare cases, you may not be able to operate your
equipment with the Sony remote control. In this case, use the
equipment’s own remote control unit.
5
3
4
1, 2
1
