38
Setup
Satellite Receiver
To connect a satellite receiver
1
Connect the satellite antenna cable (not supplied) to the satellite
receiver’s satellite input jack.
2
Use an A/V cable (not supplied) to connect the satellite receiver’s A/V
output jacks to the TV’s A/V input jacks (VIDEO 1 or 3).
3
Connect the 75-ohm coaxial cable from your cable or antenna to the
TV’s CABLE or VHF/UHF input jack.
4
Run the Auto Setup program, as described in “Setting Up the Channel
List” on page 53.
Using S VIDEO jacks? See page 31.
VHF/UHF CABLE
R-AUDIO -L
VIDEO
VIDEO IN
1
3
(MONO)
S VIDEO
S VIDEO
Rear of TV
A/V cable
(not supplied)
Satellite Receiver
CATV
cable
(not supplied)
75-ohm
coaxial
cable
Satellite
antenna cable
(not supplied)