40
Setup
Satellite Receiver
and VCR
To connect a satellite receiver and VCR
1
Connect the CATV cable (not supplied) to the single (input) jack of the
splitter.
2
Use the 75-ohm coaxial cable to connect one of the splitter’s two output
jacks to the TV’s CABLE jack.
3
Use the 75-ohm coaxial cable (not supplied) to connect the splitter’s
other output jack to the satellite receiver’s VHF/UHF input jack.
4
Connect the satellite antenna cable (not supplied) to the satellite
receiver’s satellite input jack.
5
Use the 75-ohm coaxial cable (not supplied) to connect the satellite
receiver’s VHF/UHF output jack to the VCR’s VHF/UHF input jack.
6
Use an A/V cable (not supplied) to connect the satellite receiver’s A/V
output jacks to the TV’s A/V input jacks (VIDEO 1 or 3).
7
Use an A/V cable (not supplied) to connect the VCR’s A/V output jacks
to the TV’s A/V input jacks (VIDEO 1 or 3).
8
Run Auto Program, as described in “Setting Up the Channel List” on
page 53.
Using S VIDEO jacks? See page 31.