57
Remote C
ontrol
qd
RESET
Press to reset the settings to the factory defaults. See pages 92
and 95. Also used to clear Label Channels.
qf
(Twin View)
Press to turn on and off Twin View. For details, see page 69.
qg
1
(Power)
Press to turn on and off the TV.
qh
TV/VIDEO
Press repeatedly to cycle through the video equipments
connected to the TV’s video inputs.
qj
DISPLAY
Press once to display the current channel number, and channel
label. If set, the current channel number will display for 10
seconds.
qk
0 - 9 ENT
Press
0 - 9
to select a channel; the channel changes after 2
seconds. Press
ENT
to change channels immediately.
ql
MENU
Press to display the menu. Press again to exit from the menu.
For details, see page 91.
w;
V
/
v
/
B
/
b
Press
V
/
v
/
B
/
b
to move the on-screen cursor. To select an item,
press .
wa
F1
Press to select the function of your video equipment which is
programmed on the TV’s remote control.
When
FUNCTION
is switched on
TV
Press to display the Memory Stick menu. For more details, see
“Using the Memory Stick Viewer” on page 75.
ws
F2
Press to select the function of your video equipment which is
programmed on the TV’s remote control.
wd
ANT
Press to switch between the sources connected to the TV’s
VHF/UHF and CABLE inputs.
When
FUNCTION
is switched on
SAT/CABLE
GUIDE
Press to display the program guide of your satellite program
provider.
wf
Press to select the sound effect modes:
TruSurround
,
Simulated
,
Off
. The sound effect modes can be also accessed
in the Audio menu. For more details, see “Selecting Audio
Options” on page 95.
When
FUNCTION
is switched on
SAT/CABLE
TV/SAT
Press to switch between the TV and the satellite receiver.
wg
CH +/–
Press to scan through channels. To scan quickly through
channels, press and hold down either CH.
wh
JUMP
Press to jump back and forth between two channels. The TV
alternates between the current channel and the last channel
that was selected.
wj
BILINGUAL
Press to select second language if bilingual program is
broadcasted:
Main + Sub
,
Main
,
Sub
. For details, see “Using
Button
Description