12
Installing and Connecting the TV
Connecting a VCR and Cable TV
Use this hookup if:
• You have Cable TV that does not require a cable box.
Disconnect all power sources before making any connections.
1
Connect the CATV cable to the VCR’s IN jack.
2
Using the supplied 75-ohm coaxial cable, connect the VCR’s OUT jack
to the TV’s VHF/UHF jack.
3
Using AUDIO and S VIDEO cables, connect the VCR’s AUDIO and S
VIDEO OUT jacks to the TV’s AUDIO and S VIDEO IN jacks.
Note
To watch the pictures input from the S VIDEO input jack, set “Auto YC” to “On” in the
(Setup) menu (See below).
Tips
• You can also use the VIDEO 2 IN jacks to connect your VCR.
• If your VCR is not equipped with S VIDEO, use a VIDEO cable (yellow) instead of the S
VIDEO cable.
When connecting both VIDEO OUT and S VIDEO OUT
You can select the jack the TV receives the input signal from on the menu screen.
You can set it for each video input (VIDEO 1 IN and VIDEO 2 IN) separately.
The TV is factory set to receive S VIDEO input signals.
1
Press TV/VIDEO repeatedly until the desired video input appears.
2
Press MENU.
3
Press
V
/
v
to select
(Setup), then press
.
4
Press
V
/
v
to select “Auto YC,” then press
.
5
To watch the pictures input from the S VIDEO input jack:
Press
V
/
v
to select “On,” then press
.
To watch the pictures input from the VIDEO input jack:
Press
V
/
v
to select “Off,” then press
.
6
Press MENU to exit the menu screen.
Cable
75-ohm
coaxial cable
(supplied)
S VIDEO cable
(not supplied)
VIDEO (yellow)
AUDIO-L (white)
AUDIO-R
(red)
AUDIO cable (not supplied)
VCR
S VIDEO
Rear of TV
75-ohm coaxial cable (supplied)
Summary of Contents for WEGA KLV 23HR2
Page 83: ...Additional Information 83 ...