6
XAV-7W
7
Installation procedure
Mounting example
When installing this unit, be sure to close the monitor of the unit.
If the monitor is opened while installing and given too much
force, it may cause a malfunction.
1
2
3
4
q;
6
9
9
6
9
6
7
qa
qs
qd
q;
Bend these claws outward
for a tight fit, if necessary.
Dashboard
182 mm
53 mm
Fire wall
Notes
• Do not press the front panel buttons of
the unit during installation and do not
apply strong force.
• Do not place any objects on top of the
unit.
• Be sure to use only the supplied pan-
head screws
6
for installation. If any
other screws are used, make sure they
conform to the requirements shown
below.
Using longer screws can cause internal
damage to the unit.
5 mm
6 mm
Damage can also occur if the screws are
used directly on the unit without the
brackets of the factory-installed car
stereo.
When removing front panel plate
Front panel
plate
4
Do not throw away the front panel plate,
since it will be needed when you change
the car you install the unit.
For details, see “Removing the Front
Panel Plate”. (page 17).
8
Note
• Ensure that the mounting surface is
clean.
• Do not install the connection box
- in locations subject to high
temperatures
- in locations subject to direct sunlight,
warm air from heater outlets, or
other locations that can get hot.
• When attaching the hook-and-loop
fastener to the bottom of the connection
box, do not cover the model name plate
in the center.
Hook-and-loop
fastener
8
Hook-and-loop
fastener
8
On installation surface
Installing the connection box XA-114
Cut off the required length of hook-and-loop fastener
8
and fix
the connection box
1
on the carpet or similar.
Use of connectors
Insert until the connector clicks into
place. To remove, press here and pull out.
Main unit/connection
box interconnect
3
To Media Center main unit
Hooking up the connection box
Refer also to the section “
3
Car Systems Connections” (page 13 -
15).
Insert
3
until a click is heard.
9
Refer also to the section “
3
Car Systems Connections” (page 13 -
15).
Insert
2
and
3
until a click is heard.
2
Main Unit Connections
Use of connectors
Insert until the connector clicks into
place. To remove, press here and pull
out.
To connection
box
Main unit/
connection box
interconnect
3
Power supply leads
2
(for main unit)
Insert until the connector clicks into
place. To remove, press here and pull
out.
10
Connection Example
For details, see the section “
3
Car Systems Connections” (page 13 - 15). Be sure to refer also to the
documentation for all other components in the system.
Speaker connections
SUB WOOFER
OUT(MONO)
FRONT AUDIO
OUT
SUB WOOFER
OUT(MONO)
REAR AUDIO
OUT
Notes
• Be sure to connect the earth cord before connecting the amplifier.
• If you connect an optional power amplifier and do not use the built-in amplifier, the beep sound will be deactivated.
Media Center
main unit
Active subwoofer
(optional)
Front speakers
(optional)
Rear speakers
(optional)
Media Center
main unit
Active subwoofer
(optional)
Front speakers
(optional)
Rear speakers
(optional)
Amplifiers
(optional)
Summary of Contents for XA-V7W
Page 20: ...20 XAV 7W MEMO ...
Page 79: ...79 XAV 7W MEMO ...
